Print works in initialize but not in Calculate when indicator in a Robot.

Created at 12 Nov 2020, 22:33
Subscribe
How’s your experience with the cTrader Platform?
Your feedback is crucial to cTrader's development. Please take a few seconds to share your opinion and help us improve your trading experience. Thanks!
SH

Shares4UsDevelopment

Follow

Joined 14.10.2018

Print works in initialize but not in Calculate when indicator in a Robot.
12 Nov 2020, 22:33

To debug an indicator i've set a Print in initialize and in calculate

Running  the indicator standalone will print in both cases
Running the indicator in a bot only prints the initialize message.

Is that a bug?

@Shares4UsDevelopment
Replies

PanagiotisCharalampous
13 Nov 2020, 15:21

Hi Shares4UsDevelopment,

I cannot verify your claim. I tested it and works fine for me. Please check your code.

Best Regards,

Panagiotis 

Join us on Telegram

@PanagiotisCharalampous

Shares4UsDevelopment
13 Nov 2020, 15:41

RE:

Code was OK.
Just needed to create new project with same source and restart ctrader and it worked.
Sorry I did not mentioned that before (Bit too busy i think)

 

@Shares4UsDevelopment
Copyright © 2024 Spotware Systems Ltd. All rights reserved.
cTrader Ltd offers through its group of companies the cTrader platform. The information on this website is for general informational purposes only and does not constitute financial or investment advice. cTrader does not solicit retail investors. Reliance on this information is at your own risk.